3/12/2021 0 Comments List Of Uom Iso Codes
The ISO country codes are internationally recognized codes that designate every country and most of the dependent areas a two-letter combination or a three-letter combination; it is like an acronym, that stands for a country or a state.The three letter code is also often used at events with international participants from various countries like sports meetings or song contests, where you can see abbreviations like CAN (for Canada), DNK (for Denmark), AUS (for Australia).Below is a list of two-letter codes (ISO alpha-2), and the three letter codes (ISO alpha-3), as well as the United Nations, used numerical code M49 for countries, dependencies, and other areas.Dependencies marked in Italic writing) Find by Country Name: A B C D E F G H I J K L M N O P Q R S T U V W YZ.
![]() This site introduces the code (FORM CONVERTUNITTOSAP) where the error is thrown and analyses table contents and customizing settings. Role of UNITOFMEASUREISOTOSAP in the scenario After transferring an item to SRM the UoM is checked and converted in UNITOFMEASUREISOTOSAP. Here in UNITOFMEASUREISOTOSAP the table T006 is checked if the sent UOM with ISO code exists. If it does not exists than an exception is thrown which leads to Unit of Measure XX sent from catalog is not an ISO Code and Incomplete items in catalog. In this example picture the UoM sent from catalog is DZN, which is stored in variable ISOCODE and handed over to FM UNITOFMEASUREISOTOSAP. Could you tell us which UoM is ISO or not among the above list For ISO UoM, could you give us the corresponding 3 digits code. A list of the current international ISO codes for units of measurement is available on the Internet. Here the records of T006 table where isocode is found has been selected. This records msehi attribute is handed over as sapcode value, which will be displayed in Shopping Cart as Unit of Measure of the item. In this case ISOCODE is not found in table T006, because of wrong customizing settings, so the error Unit of Measure DNZ sent from catalog is not an ISO Code. Customizing settings Lets check the above mentioned example (DNZ sent from Catalog as UoM and it leads to error) from the customizing point of view. The most common case is when someone wants to send an UoM from Catalog that is not an ISO code is that heshe sets ISO code in transaction CUNI, but nothing else. As it could be seen in the previous part, the ISO code is checked against the content of T006 table. The T006 table data are stored based on UoM settings which you can maintain in CUNI Unit of measurement. As in our example the ISO code for DZN was not in maintained in the system previously, we created this correctly, but forgot to assign it to a concrete UoM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |